RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
Search: Posts Made By: az3d
Showing results 1 to 7 of 7
Search took 0.12 seconds.
Forum: Glow Engines
02-18-2007, 08:45 PM
Replies: 54,816
Views: 5,386,971
Posted By az3d

RE: Welcome to Club SAITO !

I was using a 18x6W APC on my 70" edge 540 with a saito 150. It was awsome except it was causing the engine to overheat. I am looking for the right prop as well. I don't know if a 17x6 is enough. ...
Forum: Glow Engines
02-12-2007, 09:39 PM
Replies: 54,816
Views: 5,386,971
Posted By az3d

RE: Welcome to Club SAITO !

Ed, I think you are right about the prop. I talked to a guy at BJ's model engine service where I plan on sending my motor. He thought the load on the 18x6W prop may to much causing the motor to...
Forum: Glow Engines
02-11-2007, 02:59 PM
Replies: 54,816
Views: 5,386,971
Posted By az3d

RE: Welcome to Club SAITO !

One more thing. I do not use a fuel pump. I use the backpressure off the exhaust. could that be my loss of power problem?
Forum: Glow Engines
02-11-2007, 02:53 PM
Replies: 54,816
Views: 5,386,971
Posted By az3d

RE: Welcome to Club SAITO !

I am running a 18x6W APC prop at 2 1/2 turns out on the high end needle. Usually I use 25% cool power but they were out of it so I bought 20% cool power helo fuel. The motor has plenty of power. I...
Forum: Glow Engines
02-11-2007, 02:19 PM
Replies: 54,816
Views: 5,386,971
Posted By az3d

RE: Welcome to Club SAITO !

Hello. I am looking for some help. I have a saito 150. I wanted to send it in to have it serviced. It is leaking a lot of burnt fuel. some of it even comes out the front of the cowling. This...
Forum: Glow Engines
12-18-2006, 08:13 PM
Replies: 54,816
Views: 5,386,971
Posted By az3d

RE: Welcome to Club SAITO !

Thanks, I will try that.
Forum: Glow Engines
12-18-2006, 08:05 PM
Replies: 54,816
Views: 5,386,971
Posted By az3d

RE: Welcome to Club SAITO !

Help, I have a saito 150 I am putting on a peakmodel edge 540. I am having trouble getting it to idle low but the problem is I might be trying to get it to idle too low (about 1300 rpm). What is...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.