RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: p51delta
Showing results 1 to 10 of 10
Search took 0.11 seconds.
Forum: Glow Engines
12-26-2007, 06:38 AM
Replies: 54,845
Views: 5,414,244
Posted By p51delta

RE: Welcome to Club SAITO !

OK. Thanks guys. Sounds good. I'll give it a try and let you know how it worked out.
Forum: Glow Engines
12-25-2007, 05:54 AM
Replies: 54,845
Views: 5,414,244
Posted By p51delta

RE: Welcome to Club SAITO !

Back to my Saito 100 manifold pipe breaking and throwing the muffler:

The low speed needle is still at factory setting. (should be very rich) It did backfire once on the ground before we...
Forum: Glow Engines
12-24-2007, 04:02 AM
Replies: 54,845
Views: 5,414,244
Posted By p51delta

RE: Welcome to Club SAITO !

Something I forgot to ask in my previous posting!!!!! Yesterday while flying the Decathlon with the Saito 100. Transition from low throttle to high was good. At full throttle in the air it seemed to...
Forum: Glow Engines
12-24-2007, 01:16 AM
Replies: 54,845
Views: 5,414,244
Posted By p51delta

RE: Welcome to Club SAITO !

Hi Fellows,
I have a new Saito 100 and would like to know what would be the best prop for me. I have a Decathlon (high or shoulder wing model) 78" wingspan and run 15% nitro fuel. I just want to...
Forum: Glow Engines
10-12-2007, 03:39 PM
Replies: 54,845
Views: 5,414,244
Posted By p51delta

RE: Welcome to Club SAITO !

I beg your pardon but I'm not asking for the exact, down to the fraction of a mm, spot, to set my HS needle to so my engine will run happily ever after for the rest of it's life. I'm quite aware,...
Forum: Glow Engines
10-11-2007, 05:04 AM
Replies: 54,845
Views: 5,414,244
Posted By p51delta

RE: Welcome to Club SAITO !

How far can I lean my HS needle out on my FA-82? What end position do you guys have on your .82 HS needles after break-in? My .82 is 2 1/4 turns open right now and still smokin up a storm. I didn't...
Forum: Glow Engines
10-10-2007, 03:42 PM
Replies: 54,845
Views: 5,414,244
Posted By p51delta

RE: Welcome to Club SAITO !

I ran my new .82 today for the 1st time.I used a APC 13X6 today my LHS didn't have a 14x4. The 1st tank was on the ground, rich, and low rpm. The rest, (5-6 flights) were done in the air with no...
Forum: Glow Engines
10-09-2007, 06:52 PM
Replies: 54,845
Views: 5,414,244
Posted By p51delta

RE: Welcome to Club SAITO !

Uh Oh!!! That would be disappointing if the FA 82 & the YS .63 are similar in power. The .82 has ca. 3.5 ccm displacement more than the YS. I was hoping for a massive increase in power. It's all the...
Forum: Glow Engines
10-09-2007, 02:41 PM
Replies: 54,845
Views: 5,414,244
Posted By p51delta

RE: Welcome to Club SAITO !

So I guess I'll just use a 14x4 APC and fire up my brand new, very first Saito engine (FA-82) tomorrow. It's been waiting for me patiently on the shelf for months now. I've only had YS 4-strokes...
Forum: Glow Engines
10-08-2007, 05:13 PM
Replies: 54,845
Views: 5,414,244
Posted By p51delta

RE: Welcome to Club SAITO !

Hi Fellows!
What's the best APC prop for a FA 82. I want to try some 3D. The plane weighs just under 6 lbs. I had a YS.63 in it until now and it just wasn't quite enough. I hope it will hover...
Showing results 1 to 10 of 10


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.