RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
Search: Posts Made By: JustErik
Showing results 1 to 21 of 21
Search took 0.11 seconds.
Forum: Glow Engines
07-13-2009, 09:18 AM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

The Dawn stuff (http://www.dawn-dish.com/en_US/powerdissolver.do) comes in a spray bottle (not aerosol; the kind you pump with your fingers) and is very good at dissolving baked on castor goo. And...
Forum: Glow Engines
07-12-2009, 09:08 PM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

When will you know?








:D;) Just kidding! I couldn't see how it would matter either, but didn't want to make any stupid assumptions.
Forum: Glow Engines
07-12-2009, 08:48 PM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

Yes, but before doing so I made note of the proper orientation of the piston in the sleeve. And I noted which side of the rod faces forward. The pin is what has me stumped.
Forum: Glow Engines
07-12-2009, 08:27 PM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

One more question. One side of the wrist pin has a larger hole than the other. Does it matter which direction the pin faces when reassembling? I did't realize the ends were different until I...
Forum: Glow Engines
07-12-2009, 07:03 PM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

I was lucky enough to get them both off without losing them. :) However, I think I'll use the bag idea when I reassemble them. Right now I'm using some Dawn Power Dissolver and q-tips to clean the...
Forum: Glow Engines
07-12-2009, 12:55 PM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

So just leave the head alone? What about the valves themselves. Can I cook them in antifreeze overnight or perhaps hit them lightly with a scotchbrite pad? Or should I just leave them alone also? ...
Forum: Glow Engines
07-12-2009, 11:36 AM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

w8ye, thanks! That worked perfectly. Do I need to do anything to clean or resurface the valve's seating surfaces? And since I'm keeping the head as a back-up what about the mating surfaces in it?
Forum: Glow Engines
07-12-2009, 11:09 AM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

I know the answer must be in this thread somewhere, but 601 pages means the search is pretty useless, so here I am. :) I'm replacing the cylinder on mu 'hunnert and am preparing to pull the valves....
Forum: Glow Engines
08-27-2008, 05:23 PM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

Thanks guys, repair complete! Couldn't have been easier. Now if it would just stop raining so I can go fly. :)
Forum: Glow Engines
08-27-2008, 04:45 PM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

w8ye,

Thanks for the speedy reply. If I had just thought about it for a minute, I might have been able to conclude the same thing. :) The fact that the nut is on the OUTSIDE of the carb body...
Forum: Glow Engines
08-27-2008, 04:29 PM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

Guys,

I tried searching this thread, but with 468 pages, it's virtually impossible to get anywhere, so I'll just ask here and hope no one takes offense. I picked up a low-time Saito 100 for a...
Forum: Glow Engines
05-22-2008, 09:01 PM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

Thanks w8ye, I appreciate your help.

Erik
Forum: Glow Engines
05-22-2008, 08:27 PM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

Hello all. I tried searching the thread, but must not have used the right words. My Saito 100 suddenly won't advance past 1/2 throttle without going lean and quitting. It has run flawlessly for...
Forum: Glow Engines
04-21-2008, 02:22 PM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

Is this (http://www.horizonhobby.com/Products/Default.aspx?ProdID=SAI50GK93) the velocity stack that fits the .82?

http://www.horizonhobby.com/ProdInfo/SAI/450/SAI50GK93-450.jpg

Thanks,
...
Forum: Glow Engines
02-09-2007, 10:13 AM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

Thanks Hobbsy. I'll see what I can find in the right size.

Erik
Forum: Glow Engines
02-09-2007, 09:01 AM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

Hello Saito fans. I'm installing my first Saito in a MoJo 60 and plan to use a velocity stack. Here is a pic of the stack as installed on the engine, and the engine installed on the plane.

...
Forum: Glow Engines
12-22-2006, 10:02 AM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

w8ye,

That is the same stack that fits the 100, right? I just received my new 100 last week for a Mojo 60 and am very happy to now be a member of Club Saito. :)
Forum: Glow Engines
12-09-2006, 10:16 PM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

WOW! Thanks for the speedy reply!

Erik
Forum: Glow Engines
12-09-2006, 09:40 PM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

Let's see......that's gonna cost me 12,000 x about $15.....$180,000! Well, I guess I don't have any choice, do I. :)

So far, I've waded through the first 20 pages or so of this thread and have...
Forum: Glow Engines
12-09-2006, 08:10 AM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

Damn! I always choke on tests. :)
Forum: Glow Engines
12-08-2006, 11:11 PM
Replies: 54,811
Views: 5,382,468
Posted By JustErik

RE: Welcome to Club SAITO !

OK, where do I sign up? I just ordered a Saito 100 so can I now officially claim to be a member of this righteous club or do I have to wait until I actually have it in my hot little hands? :)
...
Showing results 1 to 21 of 21


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.