RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Nitrovein
Showing results 1 to 4 of 4
Search took 0.04 seconds.
Forum: Glow Engines
06-20-2016, 03:40 AM
Replies: 54,816
Views: 5,391,734
Posted By Nitrovein

The fully ceramic bearings I would avoid, they...

The fully ceramic bearings I would avoid, they might not be as tolerant for chock loads, but I don't know for sure.
The "regular" ceramics is used a lot in motorsports etc where there is high...
Forum: Glow Engines
06-20-2016, 03:01 AM
Replies: 54,816
Views: 5,391,734
Posted By Nitrovein

I guess that's why they use ceramic bearings in...

I guess that's why they use ceramic bearings in high rpm / high HP engines like car engines, where they excel with low oil content fuel for racing... ;)
Forum: Glow Engines
01-05-2016, 02:09 PM
Replies: 54,816
Views: 5,391,734
Posted By Nitrovein

Yeah, I meant the sharp machined one, not yours...

Yeah, I meant the sharp machined one, not yours that looks fine. :)
Forum: Glow Engines
01-05-2016, 09:13 AM
Replies: 54,816
Views: 5,391,734
Posted By Nitrovein

I did some testing on elbows with sharp corners...

I did some testing on elbows with sharp corners and they all hurt power and increased heat in the engine by a lot.
Even minor cleaning work inside the elbow helped, but I don't touch them if I...
Showing results 1 to 4 of 4


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.