RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: airborne14830
Showing results 1 to 15 of 15
Search took 0.12 seconds.
Forum: Glow Engines
10-16-2012, 10:06 AM
Replies: 54,697
Views: 5,312,143
Posted By airborne14830

RE: Welcome to Club SAITO !

Mine is a Perry VP-30 that runs from the crankcase.
Forum: Glow Engines
10-15-2012, 09:53 AM
Replies: 54,697
Views: 5,312,143
Posted By airborne14830

RE: Welcome to Club SAITO !

has anyone attached a perry fuel pump to an sa100? I attached it per the diagram, and my question is did you have to do a lot of adjustment to the pump to get hte right pressure?
Forum: Glow Engines
10-10-2012, 09:54 AM
Replies: 54,697
Views: 5,312,143
Posted By airborne14830

RE: Welcome to Club SAITO !

I am about to install a perry V-30 fuel pump with my sa100. I have seen the diagram for installing the perry with with saito engines. My questions is the my tee does not have 3 straight legs, but...
Forum: Glow Engines
09-21-2012, 10:09 AM
Replies: 54,697
Views: 5,312,143
Posted By airborne14830

RE: Welcome to Club SAITO !

I will go back and adjust the valves to see if that will help. The fuel I use is 15% Omega, and my other saito four strokes run great off of that fuel.
Forum: Glow Engines
09-21-2012, 03:13 AM
Replies: 54,697
Views: 5,312,143
Posted By airborne14830

RE: Welcome to Club SAITO !

Hobby,

I did my maiden flight with my pulse XT60. The satio was at 7800 and pulled the plane around but not with authority. You could tell the sa100 was u der power. I checked to make sure...
Forum: Glow Engines
09-20-2012, 02:51 AM
Replies: 54,697
Views: 5,312,143
Posted By airborne14830

RE: Welcome to Club SAITO !

Mike,

I am spinning a 14x8 apc prop as it outlines in the break-in instructions. After 7800 rpms and trying to tweak a little more it try's to die out and I back off on the HS needle to where...
Forum: Glow Engines
09-19-2012, 03:33 PM
Replies: 54,697
Views: 5,312,143
Posted By airborne14830

RE: Welcome to Club SAITO !

Well I tried to tweak in the HS and I could not get the rpms to go over 7800. However, the LS did idle nicely at 2000 rpms. I am hoping that my pulse xt60 will have enough power from satio 100 at...
Forum: Glow Engines
09-19-2012, 06:13 AM
Replies: 54,697
Views: 5,312,143
Posted By airborne14830

RE: Welcome to Club SAITO !

It rained here (upstate NY) pretty much all day and I have not had a chance to go back at it. Today is a better day, and I plan on tweaking the engine some more to try and get more out HS. I am...
Forum: Glow Engines
09-17-2012, 03:14 PM
Replies: 54,697
Views: 5,312,143
Posted By airborne14830

RE: Welcome to Club SAITO !

i will keep running fuel through (15% omega) and try and to lean in the high end some more. i will keep you posted after work around around 5PM eastern time

thanks
Hobbsy
Forum: Glow Engines
09-17-2012, 10:21 AM
Replies: 54,697
Views: 5,312,143
Posted By airborne14830

RE: Welcome to Club SAITO !

I have a saito 100 turning a 14x8 APC prop. Ran about threee tanks for proper break-in. The most I have gotten on the high end is 7800 RPM and the low end idles nicely at 3200 RPM. My concern is...
Forum: Glow Engines
09-17-2012, 10:08 AM
Replies: 54,697
Views: 5,312,143
Posted By airborne14830

RE: Welcome to Club SAITO !

I have a saito 100 turning a 14x8 APC prop. Ran about threee tanks for proper break-in. The most I have gotten on the high end is 7800 RPM and the low end idles nicely at 3200 RPM. My concern is...
Forum: Glow Engines
07-15-2008, 12:25 PM
Replies: 54,697
Views: 5,312,143
Posted By airborne14830

RE: Welcome to Club SAITO !

thanks W8ye,

I will give it a shot, but i am looking for more of an aerobatic type plane. Alos, I will be using a 14X8 prop. What is your recommendation for the right engine size?
Forum: Glow Engines
07-15-2008, 12:02 PM
Replies: 54,697
Views: 5,312,143
Posted By airborne14830

RE: Welcome to Club SAITO !

I have a saito 100 and is wondering if this engine has enough power to fly my 11 pound skybolt biplane? At the present it is tacking at 9300 rpms, with 15% cool power MV.
Forum: Glow Engines
07-07-2008, 02:45 PM
Replies: 54,697
Views: 5,312,143
Posted By airborne14830

RE: Welcome to Club SAITO !

Thanks W8ye,

your suggestion of making it rich before adding the glow igniter was the trick. She fired every time without spinning the prop and I had a blast flying my P-51 over the July 4th...
Forum: Glow Engines
07-01-2008, 12:44 PM
Replies: 54,697
Views: 5,312,143
Posted By airborne14830

RE: Welcome to Club SAITO !

I have a satio 100 and everytime I tried to start the engine it fires, like a back fire, and spins the prop. I check the valve adjustment and tried again, no help. It just does the same thing over...
Showing results 1 to 15 of 15


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.