Welcome to Club SAITO !
The following users liked this post:
760aaron62 (02-27-2024)
Senior Member
This SR 40 will have them exclusively.
https://www.dubro.com/products/socke...ounting-screws
I recently ordered two packages of these Dubro servo mounting screws, they have separate washer rather than a phlanged screw head. I don't know if this is an advantage or not but they work well. The washer will not come off.
Last edited by 1200SportsterRider; 02-27-2024 at 03:45 AM.
Those beauties were built about 20 miles north of here (The full-size Chris-Craft). Very popular on the big lakes around here. My Dad had one when I was about 14. It was built in 1956, beautiful, double plank hull with flying bridge. Had a pair of 310 cubic inch Hercules "JXD" inline six cylinder engines. Sounded awesome .
Okie, you buy that Saito for your plane. I'll build you the radiator and water pump.
Last edited by Jesse Open; 03-01-2024 at 07:21 PM.
My Feedback: (6)
The fellow I size up as the right collector will usually get deeply discounted price. I will gladly take less to get something into the right hands.
If it comes to hobbies; When something leaves here, money matters are well down the priorities list.
Yes, that fellow left some money on the table.
Yes, that fellow left some money on the table.
Last edited by Jesse Open; 03-02-2024 at 10:10 PM.
Nice job on the smoke mod. That old girl looks to have quite a bit of flight time on her.
Those two engine misses: Check your spark plug, cap and CDI wiring? Could be a hall sensor going bad?
Those two engine misses: Check your spark plug, cap and CDI wiring? Could be a hall sensor going bad?
The following users liked this post:
thefastfred (03-13-2024)