RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Speedrick
Showing results 1 to 9 of 9
Search took 0.01 seconds.
Forum: RC Jets
06-08-2023, 02:00 PM
Replies: 107
Views: 22,262
Posted By Speedrick

Hi, Certainly at the root of the aileron. ...

Hi,

Certainly at the root of the aileron.
Donˋt forget to dail in some expo too, this will smoothen the turns.



Greets,

Eric
Forum: RC Jets
06-07-2023, 01:08 AM
Replies: 107
Views: 22,262
Posted By Speedrick

Hi, All the same as Didier, but programmed a...

Hi,

All the same as Didier, but programmed a “Landing” flat mode, which deactivates the turbine control from the throttle stick function. (Normally, the turbine is at idle or OFF for landing)
In...
Forum: RC Jets
04-01-2023, 05:19 AM
Replies: 107
Views: 22,262
Posted By Speedrick

Hi, Surely used the provided hig speed tape...

Hi,

Surely used the provided hig speed tape - protection shield on the area, close to the exhaust.
Applied it as a normal decal, water with some cleaning detergent product, so you can slide it...
Forum: RC Jets
02-15-2023, 09:35 PM
Replies: 107
Views: 22,262
Posted By Speedrick

Hi, I would say for sure with UAT full. ...

Hi,

I would say for sure with UAT full.
As the main tank is quite centralized over the CG this doesn’t matter really, but personally, I
would fill it up 50%.



Grts,
Forum: RC Jets
10-09-2022, 05:49 PM
Replies: 107
Views: 22,262
Posted By Speedrick

Congrats on the maiden!!!!!!

Congrats on the maiden!!!!!!
Forum: RC Jets
07-30-2022, 02:08 PM
Replies: 107
Views: 22,262
Posted By Speedrick

Cockpit attachment

Hi,

After getting the thrust tube installed, and the turbine as well, the next item to install is the fuel tank.
Prior this, I think that the attachment of the cockpit would be a better idea, as...
Forum: RC Jets
07-20-2022, 09:22 PM
Replies: 107
Views: 22,262
Posted By Speedrick

Ok, sound good! At what location did you tapped...

Ok, sound good!
At what location did you tapped the spar, close to the fuse, or at the end?
Did you reinforced the wing at the location where the bolt goes thru the wing?
Forum: RC Jets
07-19-2022, 11:42 PM
Replies: 107
Views: 22,262
Posted By Speedrick

Was in contact with the Glider It team, and this...

Was in contact with the Glider It team, and this Multilock system was their recommendation too.
Must admit I’m a bit sceptic about this. Looks OK, even for a 4m glider, but I’m doubtful about using...
Forum: RC Jets
07-19-2022, 11:32 PM
Replies: 107
Views: 22,262
Posted By Speedrick

JEEMO battery config

Hello,

As completition of my JEEMO is now in the phase of the electronics installation, I was wondering which battery setup is used. Does a 2 pack installation, for receiver power, is the norm, or...
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.