RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: rustypep
Showing results 1 to 23 of 23
Search took 0.11 seconds.
Forum: Glow Engines
07-19-2009, 11:47 PM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

Saito 100. I guess I left out the important part :eek:.
Forum: Glow Engines
07-19-2009, 07:20 PM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

I was just curious what RPM you guys might be getting with a MAS 14x7 three blade on 15% Omega for a Saito 100? Thanks!
Forum: Glow Engines
09-14-2008, 05:01 PM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

What size tank do they recommend to be used with the 325 radial? What type of flight time is anyone getting with that respective tank? Thanks!
Forum: Glow Engines
07-17-2008, 06:14 PM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

It will be interesting to see how the fuel consumption is on the 115. Thanks for the initial report Hobbsy.
Forum: Glow Engines
07-16-2008, 08:35 PM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

Anyone have any feedback yet on the Saito 115. I saw one at the hobby shop last weekend and haven't see any posts on it lately. I am getting ready to do the engine selection on a 9-10 lb Spit and...
Forum: Glow Engines
07-20-2007, 08:55 AM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

My needle settings for the 100 are virtually the same too and the idle is very nice on this engine. I was peaking around 9500 with an APC 14x8 on 15% Omega after a gallon through the engine. I...
Forum: Glow Engines
07-14-2007, 11:24 PM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

Ed,

What three blade do you recommend for a Saito 100. I picked up a MA 13x8 but also saw where a few people posted about using the MA & Graupner 14x7 3 bladed props. I am planning to put a...
Forum: Glow Engines
07-14-2007, 12:14 AM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

Believe me I know. Notice how close the HS needle is to the muffler. It got hot down there but I only got one knuckle too close. The breather also threw out the ocassional bit of hot oil. You...
Forum: Glow Engines
07-13-2007, 11:59 PM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

Maybe this picture will help you see how thick the ring is compared to the stock muffler for the 82. You also have to use an extension that is the next size larger which is less restrictive. I...
Forum: Glow Engines
07-13-2007, 11:52 PM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

Not yet but I will say the raised ring on this muffler tip is deeper than I have seen on any other muffler. If you look close in the photo, I only had only tie wrap on it for the test and I...
Forum: Glow Engines
07-13-2007, 11:30 PM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

Here is my setup for the Saito 82 with another Turboheader made for the 82, Saito 90 degree header, and exhaust extension going into my new GP Reactor.
Forum: Glow Engines
07-13-2007, 11:21 PM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

Well Jim my new Saito 100 and Turboheader are keepers [sm=thumbs_up.gif]. I finished running the first gallon through as I took these numbers today. All the comments about it being a shaker are...
Forum: Glow Engines
07-11-2007, 02:20 AM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

Hobbsy,

Have you taken any numbers after you added that 90 degree adapter to see if there is any difference in performance especially since there is already a 90 degree turn in the TurboHeader...
Forum: Glow Engines
05-28-2007, 04:13 PM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

Anyone know the website or company that was selling 90 degree headers that would fit the Saitos. I remember looking at it once but can't remember it now and Horizon has them on backorder and I would...
Forum: Glow Engines
05-21-2007, 04:21 PM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

Hobbys,

Thanks for the detailed response. I have a new Saito 1.00 that I need to break in too and I just wanted to revisit the process. No problems so far but it is always good to see what...
Forum: Glow Engines
05-20-2007, 08:30 PM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

What routine is everyone using to break in their Saito's? I read both the Saito notes and the manual. The manual just says not to run it over a certain RPM for the first 10 minutes but doesn't...
Forum: Glow Engines
04-08-2007, 01:22 AM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

I have decided that I am going to put my old 40 size trainer on floats but am trying to decide which engine to use. What do you guys think a 65, 72, or 82? I still want to be able to swap back and...
Forum: Glow Engines
10-12-2006, 11:36 PM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

Anybody know where I can get the specs on the old 270T twin? Particularly the weight?
Forum: Glow Engines
08-11-2006, 05:10 PM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

Anyone know the weight of the Saito 180 muffler or the AUW of both. The engine alone weighs 31 oz but I am trying to do some calculations and don't have the muffler weight. Thanks!
Forum: Glow Engines
08-09-2006, 11:33 AM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

Thanks TC. That makes perfect sense. I was thinking a 14x6 two blade originally so 13x7 sounds like a good place to start and scratchonly reinforces that thought, albeit with an Enya :). Nice to...
Forum: Glow Engines
08-09-2006, 02:01 AM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

Yep that helps a lot. I just need to figure out which pitch is best for the 91 in a pattern plane. Any recommendations? Thanks!
Forum: Glow Engines
08-09-2006, 01:31 AM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

I am looking for a little help with prop selection for a Saito 91. I recently finished a 60 size Kaos (old tower kit version) with trike gear. The plane weighs 7 lbs even and much to my dismay a 14...
Forum: Glow Engines
07-08-2006, 03:46 PM
Replies: 54,891
Views: 5,432,878
Posted By rustypep

RE: Welcome to Club SAITO !

Did they discontinue the Saito 65? I just went to look at the specs on Horizon's website and it is no longer listed. hmmm...
Showing results 1 to 23 of 23


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.