RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: wfield0455
Showing results 1 to 25 of 42
Search took 0.01 seconds.
Forum: RC Jets
12-11-2019, 08:44 AM
Replies: 225
Views: 52,342
Posted By wfield0455

Well, since you like that I also have a...

Well, since you like that I also have a default-gain calculator spread sheet. With this spread sheet you enter the Desired total gain and it calculates the required default-gain based on the...
Forum: RC Jets
12-10-2019, 10:55 AM
Replies: 225
Views: 52,342
Posted By wfield0455

Good suggestion. I updated my previous post to...

Good suggestion. I updated my previous post to include it..
Forum: RC Jets
12-10-2019, 09:57 AM
Replies: 225
Views: 52,342
Posted By wfield0455

Definitions of values used in formula: -...

Definitions of values used in formula:
- gain-total is that actual output gain based on the combination of all other values.
- gain-function is the gain value programmed into the Assist that is...
Forum: RC Jets
12-09-2019, 05:09 AM
Replies: 225
Views: 52,342
Posted By wfield0455

Gary, So is that 40% in all flight modes or...

Gary,

So is that 40% in all flight modes or just with flaps deployed ? I was kind of suprised when you said earlier that you couldn't increase the gain in modes with flaps down. Since the gain...
Forum: RC Jets
12-07-2019, 06:22 AM
Replies: 225
Views: 52,342
Posted By wfield0455

Gary, Glad to hear your assist working well...

Gary,

Glad to hear your assist working well now and it sounds like you have a good handle on things. Just to clarify things in case others that may be following don't fully understand all the...
Forum: RC Jets
12-05-2019, 05:12 AM
Replies: 225
Views: 52,342
Posted By wfield0455

Advanced Properties->Sound on Prop. Control menu....

Advanced Properties->Sound on Prop. Control menu. Select a knob such as P7 and then select Voice output. Leave the "File' selection blank. Each time you move P7 it will announce it's new value.,
Forum: RC Jets
12-03-2019, 10:27 AM
Replies: 225
Views: 52,342
Posted By wfield0455

I have heard a couple of people mention that they...

I have heard a couple of people mention that they had issues that seemed to be acoustic interference as well so I was a bit concerned about it. Still, since they were able to reproduce it on the...
Forum: RC Jets
12-03-2019, 06:39 AM
Replies: 225
Views: 52,342
Posted By wfield0455

Harry, I'm going to guess that you had...

Harry,

I'm going to guess that you had initially setup the biplane on the Assist using the initial firmware version and had adjusted your rates and expo so that it flew nicely with that firmware?...
Forum: RC Jets
12-03-2019, 06:24 AM
Replies: 225
Views: 52,342
Posted By wfield0455

Gary, If you follow the setup steps I provided...

Gary,
If you follow the setup steps I provided post #195 then that should basically be pretty close to a damping gyro for dummies but I just realized that I missed a step and that is to verify that...
Forum: RC Jets
12-02-2019, 10:26 AM
Replies: 225
Views: 52,342
Posted By wfield0455

Since people clearly think the Assist is...

Since people clearly think the Assist is drastically more complicated than the Cortex why don't we discuss a basic Assist setup and people can comment on what they find so drastically different or...
Forum: RC Jets
12-02-2019, 05:47 AM
Replies: 225
Views: 52,342
Posted By wfield0455

Just because I provided a formula to allow you to...

Just because I provided a formula to allow you to predict your total gain based on the changes of the gain tuning channel doesn't mean you have to use it if you think it's too complicated. I simply...
Forum: RC Jets
12-01-2019, 05:58 AM
Replies: 225
Views: 52,342
Posted By wfield0455

Harry, I see your point about dividing the...

Harry,

I see your point about dividing the gain tuning value by 100 not really being necessary and to tell you the truth, when making adjustments based on gain tuning at the field I tend to think...
Forum: RC Jets
11-30-2019, 05:20 PM
Replies: 225
Views: 52,342
Posted By wfield0455

gain-default I'm simply repeating the...

gain-default

I'm simply repeating the formula from the European Jeti forum but I believe it came directly from Jeti. I'm pretty confident it's accurate. While the Assist is setup differently from...
Forum: RC Jets
11-30-2019, 07:24 AM
Replies: 225
Views: 52,342
Posted By wfield0455

Harry, The part about the gains isn't quite...

Harry,

The part about the gains isn't quite right unless I didn't read your post correctly.

The total gain value for the assist can be calculated using the formula gain-total =...
Forum: RC Jets
02-27-2018, 01:25 PM
Replies: 225
Views: 52,342
Posted By wfield0455

I'm going to have to experiment with this myself...

I'm going to have to experiment with this myself as I'm hearing conflicting info. While I'm sure 40% Elevator trim may well cause problems as that is a large value, none of my jets require more than...
Forum: RC Jets
02-23-2018, 08:32 AM
Replies: 225
Views: 52,342
Posted By wfield0455

I think philjac94 is on to something as far as...

I think philjac94 is on to something as far as the NWS goes. It does look like the Assist simply doesn't tolerate ANY trim changes on any control on any given axis. In other words, you would need to...
Forum: RC Jets
02-22-2018, 10:12 AM
Replies: 225
Views: 52,342
Posted By wfield0455

When you say flight controls jump when you turn...

When you say flight controls jump when you turn the Assist on/off with in a flight mode with elevator compensation, which controls ? I would expect that if the only change is elevator compensation,...
Forum: RC Jets
01-12-2018, 05:32 AM
Replies: 225
Views: 52,342
Posted By wfield0455

Good to know and you're certainly coming out with...

Good to know and you're certainly coming out with some very useful products which I think is great. However in my case the issue wasn't really the number of channels but rather power distribution as...
Forum: RC Jets
12-21-2017, 07:58 AM
Replies: 225
Views: 52,342
Posted By wfield0455

Well I found another thing the Assist won't do...

Well I found another thing the Assist won't do and that is stabilize UDI output. Since they have a separate"Stabilze EX Bus" control for the Central Box I'm not surprised but I had hoped it would....
Forum: RC Jets
12-21-2017, 04:48 AM
Replies: 225
Views: 52,342
Posted By wfield0455

This sounds correct to me too. With my Aura 8s i...

This sounds correct to me too. With my Aura 8s i use Separate Elevator trims for Flap to Elevator compensation all the time and it doesn't cause the slightest problem. I suspect this will work well...
Forum: RC Jets
12-21-2017, 04:44 AM
Replies: 225
Views: 52,342
Posted By wfield0455

In the Assist setup wizard. I think you will need...

In the Assist setup wizard. I think you will need to repeat the Assist calibration any time you make a significant trim change.
Forum: RC Jets
12-21-2017, 04:41 AM
Replies: 225
Views: 52,342
Posted By wfield0455

Brian, If I'm correct about needing to...

Brian,

If I'm correct about needing to perform the calibration step in the Assist setup wizard I would think you would be able to reproduce the problem on the ground / bench. For example with the...
Forum: RC Jets
12-20-2017, 03:55 PM
Replies: 225
Views: 52,342
Posted By wfield0455

So as I understand the issue, after setting up...

So as I understand the issue, after setting up the Assist you test flew the aircraft and made trim adjustments ? I assume these adjustments were made in the gyro off mode ? After making the trim...
Forum: RC Jets
12-13-2017, 07:32 AM
Replies: 225
Views: 52,342
Posted By wfield0455

I just ordered an REX7A myself. I guess I don't...

I just ordered an REX7A myself. I guess I don't have much use for my Cortex Pro anymore. By the time i sell if for typical used RC equipment price that will turn out to be one of the most expensive...
Forum: RC Jets
12-12-2017, 04:38 AM
Replies: 225
Views: 52,342
Posted By wfield0455

I hadn't heard about the PPM part of the Assist....

I hadn't heard about the PPM part of the Assist. I had heard reports that if you enable "Stabilize EX Bus" and connect it to a CB200s RX1 the CB200 it won't switch to Rx2 if you disable the Primary...
Showing results 1 to 25 of 42
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.